Breg Polar Care Pad Dryer

You'll need to print two of these, connect the narrower opening to both pad hoses, make sure it presses the black valves down. Snug fit a 1/4 air coupler to one of them.

DO NOT USE HIGH PRESSURE it will tear up the pad, use just a whisper of air (one or two psi). The idea is to let the air circulate a few hours and evaporate the water.

Place the support on the wider opening side so that the surface connecting to the pad is smooth.

Print Settings

Rafts:

No

Supports:

Yes

Resolution:

200

Infill:

50

Filament: PolyMaker PLA