Air Purifier for Creality LD-002H

Its an air purifier for the LD002H. It was highly influenced by Peeshow's Air Purifier Plus v2, which I printed. I was printing on an FDM and found it needed quite a few supports and also had quite a lot of tolerance where things went together, so everything was quite loose and wobbly.

I designed mine from scratch to push fit together and to be support free. Has space for 4x 40x40mm Carbon Filter pads, mine were 10mm high. Takes original fan but has space for upto 20mm too.

Printed on an FDM and all works well, printing in resin should be the same.

The files are numbered, 1 at the bottom and work your way up, just incase it isnt obviously how it all goes together! The fan screws on top of 1 & 2, then 3 slides over it, using the little gap for the wire.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

20

Notes:

Printed in PLA