Printed with a brim of 6, without top and bottom layer and a 0.2mm layer height.
Works as intended, greatly reduced printing noice! This is the third design I try, the previous two have all cracked under the weight of the printer after some time. Will see how long this one holds!
4/5 because I had to manually trim off the notches in order to fit the feet in the rail without taking the printer apart. This does of course have the side effect that they slip out if the printer is lifted.
I printed using FilaTech FilaFlex40, with seven perimeters using the 0.4 mm nozzle. it dampens the printer well without being too compacted.
It is so quiet now. The only thing I would say is it's kinda hard to push the feet in to place. I trim a little off of those little nubs inside of it
Printed these for my Ender 3 S1. You need 4 normal ones and 1 without that part that slides into the t-slot. It's really hard to get the feet into the t-slots. I guess the Prusa printers got bigger ones than the Creality printers.
The special one needs to be attached with glue or double-sided tape.
-filament: colorfabb varioshore 92A
-6 perimeters with 0,42mm
With these settings the feet are maybe a tiny bit to squeezed but should be perfect if you use 95A or 98A TPU. (edited)
I printed them with 6 perimeters, it was a bit difficult to insert them in my Mega Zero 2.0, and I put 3 on each side. It drastically reduced the noise level. Good design, thanks!
Very nice, great tolerances and dampening with 5+7 perimeters at 0.4 mm works great
