Elder Wand (Dumbledore Wand) from two parts with possibility printing horizontally and vertically

Because my girlfriend sat on my wand from first attempt (https://www.thingiverse.com/thing:2508722) and broke it, I searched another, because model from TonePLA was too much symmetrical and didn't look like from movie.

I decided to make my own model by combining different two models.

I took whole wand from gpass model (https://www.thingiverse.com/thing:3467035). On this wand I didn't like part with runes. Runes weren't correct and whole part was too big.

So i took another model from captfoss (https://www.thingiverse.com/thing:3265566). This model has perferct part with runes, but another part of wand(dotted part) is too symmetrical(It is wand made by death so I imagine it more historical and not uniform :-D) and i didn't like curved parts.

Whole model was resized to 15 inch (38,1 mm) from gpass 35,5 mm.

After combining these two models, wand is almost perfect for me.

Model has two parts and it is possible printing it horizontally and vertically. There is different printing and information is on another part.

HORIZONTALLY PRINTING - right side of every photo
Pros: model is stronger because line is longer, model has better detail of top of wand, better handle from lower side, printing whole print in full speed.
Cons: worse lower and upper part (print side), runes on lower and upper part is very bad, more support parts, taking out supports little bit destroy details.

VERTICALLY PRINTING - left side of every photo
Pros: better detail of every parts, runes on wand are amazing, almost no supports,
Cons: top of second part of wand must be printed on 15 % of speed, because vibration is very bad for top and result is not nice, wand is more fragile

Difference between printing is on detail of photos - top side and bottom side.

Elder wand stand you can find here: https://www.thingiverse.com/thing:4112753

Print instructions

Category: Props Print Settings

Printer Brand: Prusa

Printer: I3 MK3S

Rafts: No

Supports: No

Resolution: 0,1

Infill: 20 %

Filament: Prusament PLA Silver