Lutron Claro Faceplate

I had the idea to mount a servo motor to the faceplate so I could use Alexa to control it to turn on the fan or lights in my room. This faceplate is the first step for my idea. I figure if anyone's faceplate snaps while removing theirs, they can use this file to print a new one. Version 2 will include the housing for the servo and control board.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

.2

Infill:

15%

Filament: GizmoDorks PLA Green Post-Printing =============

Finishing

This was just a test piece for me so I wouldn't do any post processing on it, but if anyone is going to use this as their final, I would recommend using wood filler with a little bit of water to fill any of the crevices on the print. Then use a sanding sponge at 100\120 grit, 200, 300, and finally 400 with wet sanding until it gets a polished look as the original.