HB-20 compatible Lens Hood for Nikon 28-80mm

Short introduction

Had an old 28-80mm Nikon lens laying around which did not have a lens hood. So I decided to design one. I tried to imitate the original HB-20 as close as possible by using reference images I found on eBay.

About Tolerances

If it is too tight on you can try the "horizontal expansion" setting in Cura with a negative number. Same if it is too loose (but with a positive number this time).

Afterwards you might want too remove the strings (because of the missing supports) or shave some material off with a sharp knife to help everything fit.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

20

Filament: DAS FILAMENT PLA Black

Notes:

Supports may be necassary for the reversability of the hood. I was able to do it without.