Y Axis Dual Damper Mount For CR-10/CR-10S

This is a dual damper mount for the Y axis on the CR-10/CR-10s.

This can be used to mount a 2nd damper on the rear of the Y axis stepper motor in order to assist with minimization of any deflection caused when tightening the belt. The design is based around a standard Nema17 anti-vibration damper which is approx 6mm thick although due to the intended location it will be easy to adjust for different thickness dampers.

You will require 2 x M3x6mm socket head screws to mount the bracket to the rear damper plate. In order to mount a damper to the rear of the stepper motor you will need 2 x M3x35mm button head screws. An additional 2 x M4x6mm socket head screws and the corresponding 2 x M4 V-slot nuts will be required to attach the bracket to the rear frame rail.

04/04/2018 - new version added

I have added a version that has a 23mm ID as a requested alteration which also removes the slide adjusted motor/damper mount screw holes. Please note that I have not yet tested this version.

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

No

Supports:

Yes

Resolution:

0.2mm

Infill:

20%-100%

Notes:

Depending on your printer configuration you might need supports for the recessed screw holes if you choose to orient your print as shown in the sample picture. It might also be advisable to use a higher than your normal infill % due to the structural nature of the model and also to allow screws to be tightened effectively without deformation of their mounting holes.