Dread Pirate Roberts Sword

Dread Pirate Roberts rapier sword from The Princess Bride

Printed in PETG and 0.2 layer height.

Supports only needed for the pommel and the guard.

Blade pieces are numbered in the upper side: Front[1-4] & Back[1-5].

You need 5 joints for the guard (guard_joint) and 16 for the blade (blade_joint).

Once assembled, It measures 100 cm long from the tip of the blade to the pommel.

The blade is very thin and flexible (only perpendicular to the sharp edge), so it bends a bit if you turn the sword parallel to the ground.

Sanding, cyanoacrylate, sanding, more sanding, painting, ironed craft foam strip (or leather) and......As you wish.

Update 03/07/2019: Added blade_full and blade_half to allow further customization on small printers.

You can find the sheath here:
https://www.printables.com/model/180517-dread-pirate-roberts-sword-sheath
And the belt buckle:
https://www.printables.com/model/180521-dread-pirate-roberts-belt-buckle