Stackable, Modular Screw Box / Organizer

For the organization of the small components that I have around, I designed this modular box. It is easy to print, does not require support or other components.

The 1x1 box has an external dimension of 25x25mm, the wall is 1mm wide (it fits about 30 M3x16 screws). The rest of the dimensions are multiplied from this size.

Update 24.01.23 - Base_v5:

The remix created by Matt Podella corrects some problems of "Base Stand". Please follow this link:  https://www.printables.com/model/371070-base_v3_mcp

Update 12.01.23 - Base_v4:

Matt Podella: "The round-over on the alignment pegs of the base cause an overhang issue because they go all the way to 90deg overhang. I replaced them with a simple lead-in chamfer (.05" x 30 deg) which turns the overhand into bridging."

First of all, thank you very much for the richly descriptive comment. Thanks to you, I corrected the problem mentioned earlier, with a new V4 version.

Update 29.04.22 - Top_v3:

I changed the hole tolerance a bit. This way it fits much easier with a tolerance of 0.2mm.

PS:

• For the STEP File pleas follow the link: STEP File

IMPORTANT NOTE:

If you want to sell 3D prints based on my designs legally, please become a Patreon on my page and get early access to all the new designs:
www.patreon.com/levytek

All of my Designs are covered by a Creative Commons Non-Commercial License. The sale of prints using my designs is the sole right of myself, the designer, and my active Patreons to do so. Please understand that every design is workday, and multiple prototype prints to ensure quality.

THX!