I've been looking for a good tool-holder that fits my needs for a while now. There are a lot of options out there, but I wasn't really satisfied with any of them. I therefore decided to simplify this design and remix it to my liking.
Supports are required to properly print the caliper hooks.
Optionally, enable the brim, to make sure the print doesn't lift from the bed.
Optional: Add Tray Inlay
For a flat surface in the tray, print the Tray-Inlay and glue it into the tray bottom using super glue.
The author marked this model as their own original creation. Imported from Thingiverse.