A small mount for a PTFE tube.
Enables me to guide the filament through a teflon tube to the printer. Fits standard Norwegian shelf boards ("hobbyplank"), which is 18mm thick. I use some pieces of tape to shim it to make it really snug. I usually place something over the filament roll, to prevent it from collecting dust. This mount makes it a lot easier to handle.
The hole for the PTFE tube might need to be drilled out to 4mm, it will probably be a little too tight (at least it was on my printer).
The author marked this model as their own original creation. Imported from Thingiverse.