Gears for front/rear drive belt for classic Kyosho Spider EP / TF2 from the 80/90's chassis - the ones that get chewed up often when stones get in the drive train. These are not easy to find anymore.
Test printed on Ultimaker 2+ with ABS on a raft. Would reccommend trying without the raft as the bottom is a little distorted.
Printer Brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.4mm
Infill:
100%
Notes:
Ultimaker 2+
ABS (Dream3D.co.uk)
230C - Extruder Temp
100C - Bed Temp
0.1mm Layer Height
41.7mm p/s
Cooling on
Recommend trying without raft and some supports. I would also recommend trying as a single piece.
AutoCAD
Category: R/C VehiclesThe author marked this model as their own original creation. Imported from Thingiverse.