Profile 4040 Power Supply holder - 5V 12A - for OctoPI/LEDs

This thing came about due to my need to not have my Meanwell type power supply (5V 12A PSU), which I use to power my OctoPI and LED strips, lying about separately from my 3D printer.

It is mounted to the 4040 extrusion on the lower right side of my Ender 3. You would need to slide the holder in onto the 4040 extrusion just deep enough to allow for the original end cap to be replaced back onto the end of the extrusion.

Just be mindful of the X-gantry and leave a gap for that when at the lowest point so as to not obstruct it.. you might need to cut away some of the back most “sliders” to fit the 4040 cap. 

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Rafts:

No

Supports: 

Yes

Resolution:

0.2

Infill: 

20%

Filament: Any PLA / Any any

Notes:

Print upright with a brim and supports touching build plate option for the rails.

Category: 3D Printer Accessories