Folding Table

The model is based off of a small wooden table that I own that folds up in a somewhat unique way and has a handle that you can carry it around with. I have rarely seen tables that fold like this and I thought it would be fun to make it 3D printable.

Unless otherwise noted, you will need to print one of each part. Parts that need multiples are marked “x2”. I downloaded 4 different sets of files-Pre-placed on bed, cut to size, whole, and dovetailed (which is cut to fit on the bed but now with dovetails) 

Instructions have been added as a PDF

Model Dimensions:
Folded
38.5cm x 7.5cm x 52cm (approximate)
Un-Folded
39cm x 39.5cm x 45cm (approximate)

Print Parameters I used (going for strength otherwise use your go-to):
Supports, everywhere- yes but they should be minimal
0.3mm layer height
0.45 line width
4 perimeters
4 top/bottom layers
5% gyroid infill

Note on G-Code files: I print fast, speed is set to 120mm/s, so make sure your machine can handle that