In place and working: no magnet used.
Thrustmaster T.16000M Throttle Upgrade
Thrustmaster T.16000M Throttle Upgrade with LM8LUU and magnetic detents at 50% position.
56
390
3
4807
updated
November 25, 2022
Makes
Comments
Where exactly is the insert supposed to go?
Hi, this looks great and going to try it but can you elaborate on what size the m3 insert should be (4, 6, 8 mm?), and where to glue the Magnet_50, there are holes on the part that seem to be a place for magnets but not for this part.
@HoboJelly_447259 My M3 inserts have 5mm OD and are 4mm long. Just make sure to push them in until the top surface is flush with the print.
I don't quite understand the question about the magnets. You have to insert two of them in the sliding part and one corresponding in the stationary magnet parts. To install them in the 50% position I used a tool align the slider to 50% and then glue the stationary parts in the throttle housing. Unfortunately this is pretty difficult. But with patience it will work.
@Eondar Thanks for the answer and please disregard the 2nd question, I read it wrong at middle of the night and asked a stupid question
