F450 type quadcopter top with APM Dampener Mount and taller arms

I liked the design, but the mount for the apm was a little flimsy and a little small. So I took two items and mated them together. I also made the top plate 3mm instead of the original 2mm to add additional strength.

There is also a file for the arms that are 6mm taller because I wanted to fit a large battery in the middle rather than underneath where my gimbal would go.

Also added a file with the gps post already on the plate, and a file for the bottom plate with holes enlarged for standard gimbal attachment:)

The apm mount that I used is located here http://www.thingiverse.com/thing:160655

It is the Omnimac_APM_Mount_v1.5_bottom_plate file so the top plate must be the Omnimac_APM_Mount_v1.5_top_plate file

Thank you both for these wonderful files!

Print Settings

Printer Brand:

Robo 3D

Printer:

R1 ABS + PLA Model

Rafts:

Doesn't Matter

Supports:

Doesn't Matter

Resolution:

.2 or better

Infill:

20%

Notes:

For dampeners use the 9mm x 13mm or earplugs :)