A printed wheel retainer intended for Banebots P61 gearboxes and Banebots Wheels. This part replaces the snap ring that normally goes on the hub.
#10-32 x 1/2" screw with loctite is used to retain the hub to the gearbox shaft.
The STEP file is included.
Overall Width: 30mm
Overall Height: 7mm
Material: Overture Highspeed TPU - Grass Green
Vertical Perimeters: 4
Horizontal Perimeters: 5
Infill: 18%
Infill Type: Rectilinear
Printer Utilized: Voron 2.4
No supports or post processing is required
Category: R/C Vehicles
The author marked this model as their own original creation. Imported from Thingiverse.