LP Cover Holder

This is a set of basic wall mount corner brackets to mount a standard LP album cover to a wall. If you just want to print a single set you only need the file LP Cover Holder Set.3mf. I included the 4 pieces as additional separate files for convenience. Print settings below.

Layer Height: 0.20mm

Material: PLA/PETG

Perimeters: 4

Enabled Detect Thin Walls (this was precautionary only).

In addition to the above 3d printed files you will need 4 countersunk screws and an appropriate anchor method (drill into studs, drywall anchors, etc.)