Battery holder insert for IKEA Trådfri remote

Don't you hate it when the little plastic thingy that holds the battery in place breaks off? After trying something else to hold it into place, which kind of worked for a while, I decided to solve it properly by printing something that snaps into place, stays there and holds the battery where it belongs.

If you want to make this, check whether your remote looks the same as mine on the inside. The newer versions look a bit different, so this piece may not fit properly.

Print Settings

Printer:

GeeeTech i3 Pro C

Rafts:

No

Supports:

No

Resolution:

0.1mm

Infill:

100%

Notes:

printed in PLA at 100% infill because it's hardly any plastic at all and it'll certainly be strong enough that way.

no post-print finishing required. Just push the thing into place like shown in the pictures.