Broke my front mudguard (by over tightening the screw) after replacing my front tire. Definitely needed when driving through the rain!
Position the model on it's side on the build plate. Support on the wheel side probably isn't necessary.
Printer Brand:
Creality
Printer:
CR-10S
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.2
Notes:
I changed my Cura settings so that supports were not generated on the wheel side of the mudguard.
Category: Replacement PartsThe author marked this model as their own original creation. Imported from Thingiverse.