Cable Routing for NEMA 17 Stepper Motors

I had been wanting to clean up the cables on my Ender 3 Pro so I decided to make a simple cable routing support that mounts to the NEMA 17 extruder stepper motor.

For the MicroSwiss direct drive setup, the stepper needs to be removed to slip the lower bracket under, but it's a simple process. 

#4-40 hardware was used to clamp the upper and lower brackets. I did have to ream the screw holes a little to keep the screws from threading into the plastic, but I just used a small screwdriver to do so.

Printed in PETG with 0.2mm layers.