Lego Head Planter - easier print

Over on Thingiverse, 3DJake uploaded a design of an enormous Lego Head Planter (https://www.thingiverse.com/thing:4907535). I tried to print it several times with no luck because I couldn't get the overhangs right. Even with support material it was impossible for me.

So I redraw the head completly and “improved” the situation. I made the bottom thinner to safe a bit of material and the slopes are better printable. 

I printed the head with 0.2mm layer hight without any support. Only 3 bottom and 5 top layers, as well as at least 3 walls (0.4mm nozzle), 10% cubic infill, using around 250g of material. (It took about 8.5hours on my vCore3 @ ~150 to 160mm/s)

For the applications you will need supports. You can use all applications of their set, but I include them in this download. 

If you like the design, please visit the page on thingiverse and give them a like!

Thank you 3DJake! :)