Holder for IKEA Laksevåg remote

DIY project for a storage bed, two holders for Ikea Laksevåg motorized bed base remotes.

• Below is the settings I used to make good quality print.
• Tight fit, read note below.

The Storage Bed Frame Project by Henri Rantanen

Also check out the Ikea Laksevåg bed base.

Print Settings

Printer Brand:

Ultimaker

Printer:

Ultimaker 2 Extended

Rafts:

Doesn't Matter

Supports:

No

Resolution:

0.15

Infill:

18

Filament: Ultimaker PLA

Notes:

• Print time on Ultimaker 2+ was about 6 hours
PLA springiness holds the remote in place, fit is tight. Will hold the remote upside down.´Need two hands to get it off. If you prefer loser fit, recommend to scale it up depth-wise (dimension with the smallest width) a hairs width in the slicer.

Post-Printing

Ready printed holders. Manually drilled holes with sinking for screw heads.



Holder with the remote in. Notice the corners that wrap around the bed-post, you might have to remove those.