Pill Dispenser | Fridge Magnet | Pokemon

Keep your daily pills, vitamins, or even candies organized and always within reach with this dispenser. 💊 Featuring 14 compartments and a simple push-button mechanism, the center section rotates with each press and releases a single item from the bottom. 🚀

• Dimensions: Ø120 mm × 32 mm 📏

• Fully printable design, including the spring (Spring can be printed from standard PLA)

• Attach using integrated magnets 🧲

  • Inside 01_Center there are 4 holes (Ø7.5 × 3.5 mm) designed for magnets.

  • You can use any magnets that fit within these dimensions. I personally used 6×3 mm magnets, but smaller sizes will work as well.

  • To insert the magnets into the print, you must pause the print at layer 20.

• Or mount it with double-sided adhesive tape wherever needed

• Assembly Video Here

Assembly Notes

• It is important to correctly orient 05_Button during assembly.

• The correct orientation is shown in the reference image included with the model.