Prusa Mini+ Display back cover USB + Switch

Remix of several back covers to fit the usb extension linked below. I placed the USB and the on/off switch so they are not visible while still being well accessible. The on/off switch is on located on top, while the usb is on the side.

The cover with the 4 spacers need minimal support and print in under 3 hours.

You will need 4 screws. Either M3x14mm, M3x15mm or M3x16mm.

Link to the USB extension: https://www.amazon.de/-/en/gp/product/B097P84FYG/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&th=1

For the on/off switch you will have to extend the wires of the switch. This isn't hard to do, but still: Please only do so, if you know what you are doing. I take no responsibility for it.

Cover photo is from a Make kindfully provided by Citelis