FabScan CUBE Turntable

A complete turntable with holder that mounts on the stepper motor shaft. Stick a M5 nut in the slot and a M5 screw to hold it firmly in place. This is inspired by the Stepper Shaft Thumbwheel though I remodeled this from scratch in Autodesk Fusion 360. In addition I added the thin cross lines on the top to show the center. I printed this with the top down on the bed, 0.2mm layers with 25% infill, 4/4/4 top/bottom/outer layers in beige PLA. I added manual support in the two sections of the horizontal hole.