Clean Air Redirector - Jure Filter

Did a slight resize of the clean air re-direct duct by zuspiel in to match up the mounting holes to those on filter sandwich made by JKSniper.

http://www.thingiverse.com/thing:2105113

Print with the same settings zuspiel reccomended. To mount to JKSnipers filter you will need M3 screws with a length equal to 6mm (For the cover) + Redirect Duct Mount Hole Thickness + Bracket Thickness (For however you mount it if you follow the original plans) + 3-10mm (Depth of the hole on the filter duct). I am still in the process of printing a fill size redirect for myself but I did a few layer test print to ensure the holes lined up so everything should be good to go. Post a comment if there is any issues. I will update soon when I have more exact thickness measurements for the duct mount holes. My planned solution will be JKSnipers duct -> JKSnipers duct rear cover -> this redirector -> zuspiel's mounting brackets.

Edit (June 18, 2017): Photo added to show my print orientation. It should just import to slicer in proper orientation as far as the correct side down. I personally just rotated on the bed 90 degrees for a better fit. Green is supports throughout the entire inner cavity. I just left them the default settings after enabling them in slic3r. They will be tricky to remove. You will need long pliers. The supports are a must to allow the top to be bridged.