Star Trek TNG Shuttle Goddard Replacement Door

With the away team stranded on the planet, it was up to Worf and Riker to fabricate a replacement door for the rear of the shuttle, so they could get above the layer of radiation that was preventing them from being beamed back aboard the Enterprise. . .

I found this well worn Shuttlecraft at the thrift store and decided to rebuild it.  A friend was able to send me a good scan of the decal/stickers but I needed to keep the crew inside.  After a few iterations with paper and cardboard and Inkscape, I got a shape and size that I was satisfied with, and used Tinkercad to convert that into a model that could also be easily printed.  I do not have the cargo pallet, so I have not checked to see if the thicker door interferes with it being inside the shuttle.  

Feel free to remix, resell, or whatever.  Embed a magnet to act as a latch.  Remove the lever so it looks like a film model.  Add a circuit so that it goes "PING!" Knock your bad self out!

I have sliced and printed this in Cura and Prusa Slicer.  Tree Supports work better than traditional supports, but both came free with minimal adhesion.  The outer lip is only 1 mm thick, so make sure your layer adhesion is good or there will be splitting and it wont stand up to play.