Openbuilds Bondtech BMG-M Mosquito Adapter

Adapter for BMG-M with mosquito and BMG mounting plate.

Designed to be printed without supports.

Edit: while upgrading I found a happy accident! The Duet3 Tool board (1LC) perfectly fits the 3 accessory holes placed at the top of the main mount. (Picture included)

Printed on .4 nozzle in PETG.

Air dams / outlets help vent air from mosquito fan away from print.

Built in mount for BL touch right behind hotend, protected by air dams.

W/ wiring passthrough against the plate.

Use M2 screws for the BLTouch with washers so it doesn't poke beyond the hotend mounting plane.

Bondtech plate mounts with M4 screws

Fan mounts with M3 Screws.

Three holes at the top are for you to design your own wire management as need / if needed. (M3 Hole Sizing)

Top 2 holes are for the cable drag chain attachment, that puts the screw hole in the channel of the openbuilds c-beam to give extra room, mounts with low profile openbuilds M5 screws

2 centered holes on either narrow side are for an M5 screw if needed for axis homing / end stop switch, works perfectly with my C-beam micro switch plates. (allows extension so fan doesn't hit anything.

Will design and post 2nd fan soon.

I personally use a tap on most of the holes at least for the first few threads.

I also print with 100% infill, but you can play around, just try to make sure it's pretty stiff

Print Settings

Printer:

Custom Made Cartesian w/ Servos

Rafts:

No

Supports:

No

Resolution:

0.4

Infill:

50+%

Filament:

Transparent Red