Air360 Stevenson Screen Enclosure
Description
PDFAir360 Stevenson Screen Enclosure is an outdoor housing for the air360 air quality monitoring station.
The enclosure is designed to place the air360 ESP32-S3 shield, the controller board and connected sensors inside a ventilated protective body. It helps reduce the influence of direct sunlight and rain splashes while keeping airflow around the sensors.
This enclosure can be used for outdoor and semi-outdoor environmental monitoring, air quality measurements and Sensor.Community compatible monitoring setups.
Compatible Air360 shield
Firmware repository
Firmware user guide
Map
What you need to buy
In addition to the printed parts, the following hardware is required for assembly.
Item | Quantity | Notes |
|---|---|---|
M4 threaded rods | 3 | Used as vertical rods for stacking the base plate, rings and top cap |
M4 nuts | 9 | For M4 threaded rods and M4 screws |
M4 washers | 9 | For M4 threaded rods and M4 screws |
M3 × 12 mm screws | 6 | For attaching the sensor mounting grid to the base plate |
M4 × 30 mm screws | 2 | For attaching the pole mount bracket to the base plate |
M4 nuts | 2 | For M4 × 30 mm screws |
M4 washers | 4 | For M4 × 30 mm screws |
M4 × 55–60 mm screws | 2 | For mounting the enclosure on a 35 mm pole or pipe |
M4 nuts | 2 | For M4 × 55–60 mm screws |
M4 washers | 4 | For M4 × 55–60 mm screws |
Cable ties | As needed | For attaching the air360 shield and sensors to the mounting grid |
Tags
Model origin
The author marked this model as their own original creation.