Ottimo
Makes
Comments
I know the design says bracelet, but I couldn't resist - printed at 10% size with 0.2 negative volume cylinder cut out in Prusa Slicer (I love this feature) gets you great earrings. Printed in PLA 0.8 mm layer height and one color change in the middle. needs a brim and the brim is quite a pain to remove in this scale, but helps a lot.
Original bracelet posted for size comparison, finished earrings were combined with another model, so I'll post there later -
( Hummingbird earrings by 3Dave )
Two finished versions for now, both in PLA, one printed with 0.08 mm layer height, the other 0.2 mm and 80% size to fit on kids hand.
Needs to be printed with a brim of at least 5mm and even then not every print stays on bed till the end, but the design is very nice and worth some extra attempts. As you can see on photos 0.2 mm layers are too much, probably don't go over 0.12 for a nice result. I have some more ideas, so hopefully I'll add more makes (or re-makes) soon. Thank you for a nice design.
Would love to see the TV.Mostly how it fits.