Keychain Swatch (Keyring)

Keychain that doubles up as filament/colour swatches.

To chain them you will need to pause mid print and add the already completed keychain.

There are 3 versions uploaded. One is just the keychain the others have a support built into the model to have room to link with the rest of the chain. The two versions have 0.1 and 0.2 gap between the support and the keychain, the gap should match your layer height.

The support should just snap off easily. I have printed this in cura and you may want to toggle the setting ignore small z gaps to have no slicing errors on the bottom layer after the support.

Print Settings

Printer:

Anet Am8

Supports:

No

Resolution:

0.2

Infill:

Any