Ender-2 Pro BLTouch Mount

I recently purchased an Ender-2 Pro for myself as a fun little side printer (My main printer is a heavily modified Ender-3 V2). I really wanted to install a BLTouch on it, but none of the "official" creality mounting plates work with the tiny x-axis carriage. I couldn't find anything here on Thingiverse that could help, so I decided to model something myself. Here it is! Also, I had the STL for the petsfang duct BLTouch mount so I decided to use that to mount to the bracket. Well, have fun.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.3mm

Infill:

55%

Filament: Fulament Matte PLA Red

Notes:

I used a 0.6mm nozzle because it prints faster. You shouldn't have any issues printing at 0.2 mm layer height, I just like to print at 1/2 my nozzle width.

Mounting the probe

To mount the BL Touch to the carriage plate, I printed the ALL_BLT_LEFT from Thing:4759439 (This is from the petsfang duct thing page). I then used two screws to attach it directly to the mounting plate I made.
The offsets that you need to put into your firmware are X: -43.5 Y: -7.3 Z: -1.82 (though I recommend running the Z-probe offset wizard once you have everything installed to adjust it to your liking).