Miniature Sawhorse

Classic carpenter's sawhorse, the type we all made in woodworking class or on the job. Tool tray near middle. There's two files - half the horse and a connecting piece. Print two halves and glue together using the "board" to connect and align using the groove under the top piece.

When printing, pay attention to the seam, Since one half is flipped when you glue it, and this is so small, the seam can be obvious. I import the half model twice, then rotate one 180 degrees. That way the seam aligns. 27mm tall. Can be scaled up or down. Scaling down by more than 50% will result in parts that are too thin.

I also took the "2x4" piece used for joining the two halves and stretched a few copies - great for some lumber around the job.

I printed with wood colored PLA.

Post-Printing

Assemble with CA glue.

Finish up with some scratches and damage..