Phone stand with disconnecting holder

Since in this version only the stand is back-compatible it has been uploaded as a remix.

An M4 screw 10mm in length is used to secure the handle to the base of the holder, with a thin washer between the screw and the handle, and an elastic band is used as a spring for the sliding arms. 

the stand holds the holder holding the phone at a 15° angle.

.STEP for the slide included.

This version has notable improvements over the previous versions like:

• Improvements to durability due to increased slide thickness
• Longer effective span it can extend outward
• Still lower material usage then version 2
• Improved tolerances between the base and slide to reduce twisting motion
• Max recommended device width 94mm
• Max device thickness 15mm

Printed Tested With

• Printbed brand PLA, colors White & Peanut Butter
• 0.4mm E3D Nozzle
• @ 0.15mm layer height