Laniaker Passive Phone Charger Base

This is a phone charger base I created in Fusion 360 that would allow me to charge my phone with it sitting in a position where I could see the screen and use it while it was on the base charging. It is designed around the Laniaker Starship NCC1701 passive charger.

I added a small storage box to the back and holes in the box base to zip tie the cable down after you feed it through the whole to plug into the charger base.

Print Settings

Printer:

Monoprice Maker Select V2

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

30%

Notes:

This needs supports for the storage box bottom and the slight overhang at the top. Although I believe you could get away with supports from the bed only. I used Simplify 3D to add supports and the supports get added at an angle for the top part and when it starts printing them it looks like it is failing but let it continue and the supports will smooth out and finish properly.

Designed in Fusion 360

Designed this using fusion 360.
This was my first real 3D design project so its not perfect.

I will added improvements as I get more familiar with Fusion and 3D for printing.