Pololu Maestro 6-Channel Servo Controller Case (Curtain Rod)

This mount is based on the basic design shown in the Pololu Maestro 6-Channel Servo Controller Case by KikiTay.

The servo controller needed to be mounted next to the actual servo on a (curtain) rod. The hooks were attached on both sides of the case to mimic a sloth.

Print Settings

Zig-Zag support with was used for the case (bottom)

Post-Printing

The support on the pins on the side of the case has to be removed. The pin might also need to be cleaned slightly with a file to ensure that it fits into the notch of the curtain rod hooks.

Just place the controller inside the casing, attach the top (cover) and at the end push the curtain rod hooks over the case tails.