Netatmo Wind Gauge Pole Mount

Holder for Netatmo Wind Gauge for pole mount (diameter of pole is 4 cm). Designed with holes for plastic ties.

At bottom is a hole for securing gauge with screw - same size as for camera tripods. I dismounted screw form some cheap small camera tripod.

After print I discovered, that gauge is quite firm in holder, so maybe screw is not necessarilly needed :-)

I used SketchUp to design this piece. Source file included.

Still ok after 3 years - made from PLA.

Print instructions

Category: Outdoor & Garden Print Settings

Printer: Prusa i3 original
Resolution: 200
Infill: 40 honeycomb 3D