Vinyl Sleeve Mount

Vinyl Sleeve Mount

Extra Materials

• Super Glue
• Screws (get screws that have a flat head and not rounded)

Print Settings

• .2 Layer height
• 20% Infill

Post Print

You will need to superglue the plaque onto the mount. It is not meant to match perfectly with the mount, there should be an offset at the top. Just line up the bottom of the plaque and the bottom of the mount.

After you let dry for some time, use the included screw marker to align your holes.

The screw hole is recessed in the back so the screw doesn't need to go all the way through the hole. This is so you don't scrape the vinyl sleeve. See the picture with the screws and notice how I marked how much of the screw to leave out the wall.

• Pro Tip. Put the screw in the mount before you screw the screws in the wall at mark on the screw with a sharpie to know when to stop.