ROBOEXOTICA Guzman – Cocktail Robotics Mascot

Based on Richard Wientzek's original design from 2002.

Comissioned by Zwax (Thanks a thousand! <3), creator of the Amalettomat for the ROBOEXOTICA, worlds biggest festival for cocktail robotics since 1999.

Includes a nihilistic adolescent version. 

Designed in Fusion 360, no AI was used in the creation of the model.

Print instructions

• Use the .3mf file. Don't print the stl, as it's not in a good orientation for printing.

• Open as project. All parts are set to fit on a Prusa Mini. I've added a brim to the key and supports where necessary. Adjust your settings if you want to.

• I recommend printing the small parts separately, as things can go wrong with them and they might ruin your print. 

• The "Verbinder" part (the plastic cube) is not perfectly square, to avoid collisions with sagging bridges in its counterparts. Make sure you insert it with the right face (the broad side faces the model, it should fit snugly). 

• Preferably use epoxy-glue to assemble the parts. Superglue might work but i've tested it with epoxy. 

• Use copper verdigris set or iron rust effect set for finishing and hiding the seams.