Fully Parametric Phone Stand w/ Adjustable Angles, Widths, and Heights

Print Settings

Rotate the model onto its side for layer strength. I used 15% triangular infill for my print, but if you need additional support increasing the infill should be fine. If all else fails, increase stand_thickness.

Parameters

• phone_width - [mm] How wide your phone is.
• phone_thickness - [mm] How thick your phone is.
• stand_height - [mm] How tall the stand should be.
• stand_thickness - [mm] How thick the stand's supports should be.
• stand_angle - [deg] The angle from vertical your phone should be held at.
• slot_width - [mm] How wide the cable slot should be.
• gap_height - [mm] How big of a gap to leave under the phone.