Iron Man Tap Handle

An Iron Man Tap Handle I made for my kegerator. I printed in PLA at 75% with support. The hole in the bottom is for a tap handle insert. Print, remove the support including the support inside the hole in the bottom, and thread in the insert. If the hole is too small, heat up the insert and you can thread it in hot because it melts the PLA.

Print instructions

Category: Kitchen & Dining Print Settings

Printer Brand: Robo 3D

Printer: R1 ABS + PLA Model

Rafts: Doesn't Matter

Supports: Yes

Infill: 75%