Light bar for Prusa MK3s with dimmer

This is the best solution I could find to add light with a strip of 12v LED. The LED strip is glued to an aluminium corner profile for heat dissipation. The power comes from the Einsy board through a step-down power converter that converts 24V to 12V.

The dimmer is a cheap chinese LED dimmer without the original housing and inserted inside the lightbar case.

The lightbar has 2 degrees of freedom in horizontal plane thus allowing for fine tuning the angle of the light. The lightbar is designed not to interfere with the extruder not even when it is at maximum height.
For assembly you will need M3 bolts and nuts.