Mini Desk Lamp

A mini desk lamp to go with my mini raspberry pi desktop and monitors. It stands about 8" inches tall. fully extended. 

https://www.printables.com/model/172093-mini-pi-desktop-tower

https://www.printables.com/model/172094-mini-monitor-stand-7-10

I used #10-24 3/4" screws to hold this together. Four 5mm white leds, with a 200 ohm resistor on each led. they are powered from a usb cable. If you want to run this at a voltage other than 5.2, make sure to do the math to figure out which resistors to use.

Print everything in the orientation its currently in and you wont need supports. Assembly should be pretty self explanatory by the picture, I lined the inside of the socket with some aluminum foil to help with the throw of the light, but this is more of a novelty and not exactly meant to be practical.

If you have any questions, feel free to ask in the comments.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 Pro

Rafts:

No

Supports: 

No

Resolution:

.32

Infill: 

10

Filament: Hatchbox PLA

Category: Decor