Sega Dreamcast VMU Cap v2.0

I lost my old one, this was a great replacement.

i just think they're neat! (edited)

Perfect fit.

Printed reasonably well but definitely prints better with supports. Fitment is pretty good to the VMU as well.

I first tried to print these at .08 with supports all through and a brim, and it printed way worse than the recommended settings. I would have loved to have printed at .08, but I'm pretty sure the arch where the VMU connects doesn't like that layer height, as a sharp angle appeared in the curve. Might have just been the supports.

Print at recommended layer height for a sufficient print that fits well.

The image is printed with recommended settings. (edited)

Fits perfectly and the flat top makes it easier to store on the shelf. (edited)

Was able to print with just a brim and no supports using (.16mm with adaptive layers). (edited)

Fits perfectly! Printed only using supports on the outer edge