Stand for wireless phone charger

After purchasing a 15w wireless charger for my Pixel 6 i loved the look of the pad but it was awkward to line the phone up and it stopped charging when i picked it up to look at my notifications. So i made a mount to have the charger and phone sit at a 75 degree angle allowing me to use the phone while still charging, and it lines it up perfectly for charging every time.

Only fits this wireless charger: www.shorturl.at/osC68 (Amazon UK link)

Works with any USB-C cable that can bend back on itself within 5cm of the port (all the ones i tried worked fine, but some thicker braided cables may not)

• Print with supports (only necessary for the top part of the model, will bridge over the USB port). 
• No brim or raft needed
• 3-5 walls, 10% infill
• Printed in PLA 
• 77g material used (inc support)