0.25-20_Ball_and_Socket_CameraMount

Instead of the 2020 Extrusion mount in the remix by @ORDEEP, I substituted a 02.5-20 threaded stud, like those used on camera mounts.  This allowed me to then mount a Raspberry Pi Zero 2W (mounted in the Raspberry Pi Zero W Case w/Camera on Thingiverse) in my IKEA Lack Enclosure.
 

I had to crank down pretty hard on the knob to get the Pi to stay in place, but that's not too surprising given that it's holding the Pi in a horizontal position.  A little tweaking of the nut size might make it easier, but I haven't tried that yet since it's working as is.

Printed in Overture PETG, 2.0mm STRUCTURAL, 15% fill.

Replaced the 2020 Extrusion mount in the remix by @ORDEEP with a 02.5-20 threaded stud (as used in camera mounts).