Gira Hue plate

This is a Philips Hue remote plate for Gira light switches with access to the switches.

I had a look around for what I wanted, but couldn't find what I needed and ended up designing this.

This is designed to slot directly into the existing Gira wall plate and fits both single and dual rocker switches and will allow access to the switches in case your technology fails you so that you will not be left in the dark :-)

The adapter is friction fit, but I recommend gluing it to the inner frame to secure it from wobbling. Use the outer frame as a guide so you don´t put glue were it interferes with the fit.

Print this with supports, lying on it's back at 0.2 layer height. Typical print time for me 1:50 hours.

Once you remove the remote, you have easy access to the original rocker switches. I re-use the magnets from the original Hue plates, but I assume you could order these magnets if you would rather keep your original plates intact.

This has now been remixed by Regnets to fit the Gira 55 system. Head over here for that file: https://www.thingiverse.com/thing:3393897