Bottle Rocket Fireworks Nose Cone

The other day, browsing the site, I game across this Thing for a fin set for bottle rockets. Try as I might, though, I could not find a single Thing for a matching nose cone. And any model rocketeer will tell you that rockets need a proper nose cone to cut wind resistance just as much as they need find for stabilization. So... here is my contribution to Independence Day.

After printing the original fin sets, I found that they were 1mm too small to fit my 6mm diameter bottle rockets. The fins were also a little too thin for my taste. I therefore remixed those in to this version.

! Have fun andNever Forget 1776 !

Print Settings

Printer:

Tevo Tarantula

Supports:

No

Resolution:

0.3

Infill:

10%

Notes:

It is recommended that you print multiple pieces at one time to allow for proper cooling. I would suggest printing half a dozen or so of these and another half doze or so of the fin sets at one time. Seven of each at 60mm/sec is calculated to print in about an hour or so, so ....