1.25" Pool Hose Coupler

When you need a coupler to connect two 1¼" pool hoses together on a weekend out in the sticks and every hardware store is closed.... you print one :) This quick little print only takes about an hour with a 0.3mm layer height and a 60mm/sec print speed. This is a snug fit and since I'm just using this on the waste side, I didn't bother with clamps, but if you are using it on either the inlet or output of the pump, I'd recommend clamps around the hoses.

Another Sketchup Model - Debunking the Myth that Sketchup is Useless in 3D Printing

Print Settings

Printer Brand:

TEVO

Printer:

Tarantula

Supports:

Yes

Resolution:

0.3mm

Infill:

20%